Owner's Manual
Table Of Contents
- Handbook
- Safety Guidelines
- Welcome
- Contents
- Overview
- Rear Panel Connections and Controls PA720
- Rear Panel Connections and Controls PA240
- Rear Panel Connections and Controls PA410
- Control System Connections
- Front Panel Connections and Controls
- Operation
- Connecting Sources and Loudspeakers
- Bridged Mono Mode - PA240 only
- Dual Mono / Bi Amp Mode - PA240 only
- Troubleshooting
- Specifications
- Warranty
EN-8
POWER INLET
Connect the correct mains cable
here.
VOLTAGE SELECT
Ensure that the voltage
selected matches the local
power supply.
PRE-AMPLIFIER INPUTS
Connect the phono outputs of your
pre-amplier.
See “Connecting Sources and
Loudspeakers” on page EN-13.
SPEAKER TERMINALS
See “Connecting Sources
and Loudspeakers” on
page EN-13.
Please read the sections “Placing The Unit”,
“Power” and “Interconnect Cables” on page
EN-6 before connecting your PA240
amplier!
TRIGGER IN / OUT
Trigger IN allows the PA240 to be turned on or o by an external source.
Trigger OUT allows the PA240 to control the power state of other connected
equipment
See “Trigger IN/OUT” on page EN-10.
USB
For software upgrades only.
See “USB” on page EN-10.
NETWORK
This connection allows for remote control
from a third-party home automation system or
computer.
See “Network and RS232” on page EN-10.
RS232
This connection allows for remote control
from a third-party home automation
system or computer.
See “Network and RS232” on page EN-10.
Rear Panel Connections and Controls PA240
RS232 NET
TRIGGER OUT
(12V 100mA)
TRIGGER IN
POWER INLET
110-120V/220-240V~
50/60Hz 1.5kW MAX
USB
5V
100mA
SWITCH POSITIONS
115 = 110 - 120V ~
230 = 220 - 240V ~
SUPPLY
VOLTAGE
RCA
XLR
INPUT
+
4-16 OHMS. CLASS 2 WIRING
+
- -
R
ST BRIDGE DM
GAIN
25dB 31dB
MODE
L
INR INL
INR
OUTR
INL
OUTL
BALANCED XLR AUDIO INPUTS
Connect the XLR outputs of your pre-
amplier.
See “Connecting Sources and
Loudspeakers” on page EN-13.
INPUT SWITCHES
Allow the PA240 to be congured in
dierent operational modes.
See “Connecting Sources and
Loudspeakers” on page EN-13.
PRE-AMPLIFIER OUTPUT
OUTL and OUTR provide a copy of
the signal applied to the IN L and IN
R phono sockets only, not the XLR.
Note: This is a passive output,
no additional ltering or
amplication is applied.