Operation Manual

E-13E-12
English
SP1 and SP2
ese buttons allow you to switch the speakers on and
o.
e LED above each button glows green to indicate
which speakers are currently selected. If you are using
the bi-wiring conguration described on page15, both
SP1 and SP2 must be switched on.
Note that when both lights are out, the amplier will
appear not to work, as all speakers are switched o.
SP1 SP2
POWER
POWER / STANDBY
Switching on
e POWER button switches the unit on and o.
e power light (next to the ‘POWER / STANDBY’
text) indicates the state of the amplier: it changes from
red to orange then green if mains power is connected
and the unit is switched on.
P49/P349
operation
CR902 remote
control
e CR902 is pre-programmed for use with the
A49.
Make sure the two AAA batteries supplied are
installed before attempting to use the remote
control.
A. With the CR902 remote face-down, press down
on the non-slip indentations of the battery
compartment cover and slide the cover o.
B. Insert the two ‘AAA’ batteries supplied. Take
care to insert the batteries in the right direction
by following the ‘+’ and ‘–’ marks in the battery
compartment.
C. Slide the battery compartment cover back and
lock it in place with a click.
e CR902 requires a clear line of sight to the front
panel display of A49 to ensure reliable operation.
AUDIO
SACD
MENU
FM MONO P/TUNE
STORE
INFO
BD
CR902
RTN
Alternative code selection
In the rare sitatuation that the CR902 remote control
happens to operate another device in the room, the
IR code can be changed to an alternative RC5 system
number.
To change the remote control to the alternate code:
Press and hold the AMP key and press
1
and then
9
.
To restore to the original code:
Press and hold the AMP key and press
1
and then
6
.
Note: the selection of the alternate codes is reset when
the batteries are changed.
In addition to changing the remote handset, the A49/
C49 unit must also be recongured to respond to the
alternate codes. Either use the MENU button on the remote
to access the setup menu, or press the front panel SAT,
CD and MUTE buttons simultaneously and use the control
knob to change the setting. e front panel display shows
(e.g.) IR SYS 16.