HANDBOOK Arcam Compact Disc players Lecteurs de CD Arcam Arcam Compact Disc-Spieler CD 7 2 CD 9 2 E nglis h Fra nça is D eut s ch
Safety guidelines Safety instructions This product is designed and manufactured to meet strict quality and safety standards. However, you should be aware of the following installation and operation precautions: 1. Take heed of warnings and instructions You should read all the safety and operating instructions before operating this appliance. Retain this handbook for future reference and adhere to all warnings in the handbook or on the appliance. 2.
This handbook has been designed to give you all the information you need to install, connect, set up and use the Arcam CD72 or CD92 compact disc players. The CR-314 remote control handset supplied with this equipment is also described, as it applies to operating the CD players. Safety Safety guidelines are set out on the inside front cover of this handbook.
Installation Remote input connection Positioning the unit Always place the CD player on a level, firm surface. Placing your player on a set of dedicated sorbothane isolation feet will isolate the unit from its surroundings as well as absorbing the vibrations created within the player itself. You will generally hear some sonic improvements, which makes this an extremely cost-effective upgrade. Connecting to other equipment Interconnect cables Interconnecting cables are not supplied with this CD player.
E ng l i s h Using your CD player COMPACT DISC PLAYER LOAD PLAY STOP PAUSE 2 8 3 4 5 POWER 1 SKIP TRACK Press this button to switch the CD player on and off. When first powered up with no CD installed the display shows: 2 To install a CD, press LOAD (or OPEN on the remote control). The CD tray opens – it accepts 12cm and 8cm discs. Place the CD in the tray with the label facing uppermost. Press LOAD again (or press PLAY, or gently push the tray in 5mm) to close the tray.
Using the remote control CR-314 Remote Control Note that greyed-out buttons on the remote control are DVDspecific and are not used with the CD player. CD/DVD 0–9 keypad Ensure that CD mode is selected using the CD/DVD toggle button. The ‘CD’ LED above the CD/DVD button is lit briefly when CD mode is selected. This allows direct access to individual tracks on the disc. To select a track, press the corresponding keypad button and then press . For tracks greater than 9, enter the digits in sequence.
Digital to Analogue conversion CD72: 24-bit multilevel Delta-Sigma DAC CD92: High resolution proprietary multi-bit current output digital to analogue conversion. 24-bit dCS Ring DAC plus HDCD Laser pick-up Laser wavelength Numerical aperture Dynamic range Signal to noise ratio (CCIR) Harmonic distortion (0dB, 1kHz) Frequency response (±0.5dB) Output level (0dB) Output impedance CD72 CD92 Minimum recommended load 3 beam 780nm 0.45 106dB >100dB <0.005% 5Hz–20kHz 2.
Guarantee Worldwide Guarantee This entitles you to have the unit repaired free of charge, during the first two years after purchase, at any authorised Arcam distributor provided that it was originally purchased from an authorised Arcam dealer or distributor.
