HANDBOOK Arcam CD93 Compact Disc player Lecteur de Disque Compact Arcam CD93 Arcam CD93 Compact Disc-Spieler CD93 English Français Deutsch
Safety guidelines CAUTION ATTENTION RISK OF ELECTRIC SHOCK DO NOT OPEN RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: To reduce the risk of electric shock, do not remove cover (or back). No user serviceable parts inside. Refer servicing to qualified service personnel. WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
This handbook has been designed to give you all the information you need to install, connect, set up and use the Arcam CD93 compact disc player. The CR-314 remote control handset supplied with this equipment is also described. Safety Safety guidelines are set out on the inside front cover of this handbook. Many of these items are common sense precautions, but for your own safety, and to ensure that you do not damage the unit, we strongly recommend that you read them.
Installation Positioning the unit Connecting to a power supply Always place the CD player on a level, firm surface. Placing your player on a set of dedicated sorbothane isolation feet will isolate the unit from its surroundings as well as absorbing the vibrations created within the player itself. You will generally hear some sonic improvements, which makes this an extremely cost-effective upgrade.
English Using your CD player COMPACT DISC PLAYER CD93 24 BIT / 192 kHz UPSAMPLING TECHNOLOGY LOAD 2 POWER PLAY STOP PAUSE 3 4 5 6 SKIP TRACK 1 Press this button to switch the CD player on and off. When first powered up with no CD installed the display shows: TRACK POWER 7 1 7 To start a CD with a track other than the first, press to locate the desired track. To select another track during play, press is played automatically after selection. --NO DISC-- or or .
Using the remote control CR-314 Remote Control Note that greyed-out buttons on the remote control are DVDspecific and are not used with the CD player. CD/DVD 0–9 keypad Ensure that CD mode is selected using the CD/DVD toggle button. The ‘CD’ LED above the CD/DVD button is lit briefly when CD mode is selected. This allows direct access to individual tracks on the disc. To select a track, press the corresponding keypad button. For tracks greater than 9, enter the digits in sequence.
Digital to Analogue conversion High performance 192kHz 24-bit sample rate converter and multiple 24-bit digital to analogue conversion NOTE: All specification values are typical unless otherwise stated. Continual improvement policy Laser pick-up 3 beam Laser wavelength 780nm Numerical aperture 0.45 Signal to noise ratio 114dB Radio interference Harmonic distortion, 24-bit (1kHz) <0.0008%* Frequency response (±0.2dB) 0.
Guarantee Worldwide Guarantee This entitles you to have the unit repaired free of charge, during the first two years after purchase, at any authorised Arcam distributor provided that it was originally purchased from an authorised Arcam dealer or distributor.