Operation Manual

E20
technical
specication
Pre-amplier
Inputs
Maximum input level 2.5Vrms
Input impedance
47kΩ
Signal/noise ratio 105dB
Co-axial outputs
Maximum output level 2.5Vrms
Output impedance
500Ω
Optical output (TOSLINK)
Sample rate 44.1kHz (with CD playback),
48kHz (with DAB, FM, NET & USB receiver),
otherwise muted.
Amplier
Continuous power output, per channel, 80kHz measurement bandwidth
Both channels, 4Ω, 1kHz
75Wrms, 0.013% THD+n
Distortion, both channels 4Ω, 80% power, 1kHz
0.011% THD+n
CD playback
DAC Wolfson 24-bit multilevel Delta-Sigma DAC
Frequency response (±0.5dB) 20Hz–20kHz
DAB receiver
RF tuning range 174.928—239.200MHz (Band III)
1452.960—1490.624MHz (L-band)
Sensitivity (typical) –97dBm
Input impedance
75Ω
FM receiver
RF tuning range 89.5–108MHz
Sensitivity (typical) -108dBm
Signal/noise ratio (at 200mV) 50dB
Distortion (THD at 200mV) 0.3%
General
Supply voltage* 100V, 115V or 230V AC,
depending on shipping region
Power consumption Standby 1W;
Operational 25W (typical), 400W (maximum)
Size (W x D x H) W430mm x D350mm x H79mm
Weight (net) 7.75kg
Weight (packed) 10.5kg
Supplied accessories Mains lead
Wire dipole aerial (Band III)
Wi-Fi antenna
Remote control handset and two AAA batteries
Instruction manual and registration card
* This is a Class 1 device and must be earthed.
Radio interference
Solo Neo is an audio device containing microprocessors and other digital electronics. It has been designed to
very high standards of electromagnetic compatibility.
If Solo Neo causes interference to radio or television reception (which can be determined by switching Solo Neo
o and on), the following measures should be taken:
< Re-orient the receiving antenna or route the antenna cable of the eected receiver as far as possible from
Solo Neo and its cabling.
< Relocate the receiver with respect to Solo Neo.
< Connect the receiver and Solo Neo to dierent mains outlets.
If the problem persists, please contact your Arcam dealer.