log o Handbook Manuel Handbuch Handleiding
CAUTION: To reduce the risk of electric shock, do not remove cover (or back). No user serviceable parts inside. Refer servicing to qualified service personnel. safety guidelines WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
contents thank you….............................................. E-3 installation................................................. E-4 Positioning the unit........................................E-4 Power.....................................................................E-4 Interconnect cables........................................E-4 Connecting to a sound source..............E-4 Care of your speaker...................................E-4 speaker positioning.................................
Positioning the unit Indicator LED Place the Logo speaker unit on a level, firm surface, avoiding direct sunlight and sources of heat or damp. < Do not place Logo in an enclosed space such as a bookcase or closed cabinet unless there is good provision for ventilation. The Logo speaker unit is designed to run warm during normal operation. < Do not place your record deck on top of Logo.
speaker positioning standing speakers), or in corners. The speaker drivers should be at, or a little above, ear level when seated. If possible, centre your seating area between the surround speakers. Room acoustics The final sound will depend on the acoustics of the listening room and experimenting with speaker positioning is very worthwhile.
Sub/full range+sat system connection This is a surround-sound system (such as Arcam’s Solo Movie 5.1) where full range L and R speakers are combined with satellite (or with full range) rear speakers. The system should be connected with both the Sub, Subwoofer or LFE output connected to IN LFE and Left/Right preamplifier outputs attached to IN L/IN R on Logo. LS RS PRE OUT SUB PRE OUT RIGHT PRE OUT LEFT In such systems, Logo can be set up to work with two crossover frequencies.
The subwoofer’s has two jobs: firstly to reproduce accurately and with sufficient power the sub-bass that other ‘smaller’ speakers cannot (the centre speaker is almost always a ‘small’ speaker); and secondly to reproduce the ‘.1’ or low frequency effects (LFE) track of 5.1 or 7.1 material. Recommended settings for use with Muso speakers Arcam’s Muso satellite speakers ideally complement the sound quality and design values of Logo.
Technical specifications specification System design One-way speaker, with 10 litres internal volume. The cabinet is solidly constructed from machined MDF with internal bracing. Drive unit 10” (254mm) subwoofer drive unit with long excursion, magnetically shielded. Frequency range 20Hz to 250Hz Impedance 4Ω nominal Sensitivity 85dB/watt, measured at 1m Crossover Fourth order Linkwitz-Riley crossover circuit, 24dB/octave (80dB/decade), adjustable for frequency and Q.
