Product Manual B

SpecificationS:
Overall Tray Dimensions: ......28-7/8" x 19-7/8" x 1"
Main Tray Area: .....................28-1/2" x 16-7/8" x 1"
Small Compartments ................9-1/2" x 2-3/4" x 1"
1.5mm gauge steel
Low Height: ......................................................... 34"
High Height: ................................................. 47-3/4"
Overall Lenght: ............................................. 32-3/4"
Overall Width: ............................................... 20-3/8"
Shipping Weight: ......................................... 39.7 lbs.
Tools Needed to Assemble Unit:
17mm Wrench
14mm Wrench
paRtS LiSt:
Part# Description ............................................. Qty.
1. Top Tray ......................................................1
2. Rubber Corner Bumper w/Pins ..................4
3. Small Plastic Insert .................................... 4
4. 14mm Bolt with Washer ........................... 12
5. Adjustable Tube (silver) ..............................1
6. T-Bolt ..........................................................1
7. Right support .............................................1
8. Large Plastic Insert .................................... 4
9. 2" Caster with Nut......................................4
10. Tube Support .............................................1
11. Left Support ............................................... 1
12. 17mm Bolt with Curved Washer .................1
13. Ball Bearing Slide .......................................2
14. Drawer Unit ................................................ 1
15. Aluminum Handle .......................................1
NOTE: Only Part #9 available separately as
RS8018CS - Caster with nut
A
r c A n Pr o f e s s i o n A l To o l s cu s T o m e r se r v i c e
1 800 879-7316
MODEL AWT8019
Deluxe Work Table
aSSeMBLY inStRUctionS:
1. Using four 14mm bolts, washer and nuts, install
one caster in each square hole on the bottom
edge support (#7 & #11).
Be sure the square bolster on the post of each
caster inserts fully into the square hole in the
support before fully tightening.
2. Using four 14mm bolts and washers, attach the
bolt plate on the right support (#7) to the
bracket on the tube support (#10), ensuring
that the casters are facing down. Be sure bolts
are securely tightened before proceeding.
3. Slide left support tube (#11) into the tube
support (#10) and secure with 17mm bolt and
curved washer (#12). The curved washer should
conform to the tubing wall.
4. Laying the top tray (#1) upside down on the
floor, attach the mounting bracket on silver
adjusting tube (#5) to the bracket on the bottom
of the tray, being sure the adjusting tube faces
AWAY from the center of the top tray.
5. Now, slide the silver adjusting tube with top
tray attached into the tube support (#10) and
secure at the desired height with the T-bolt (#6).
6. Attach four rubber protector bumpers (#2) by
pushing the black plastic pins provided into the
holes in the corners of the top tray. The pins
are inserted from OUTSIDE the tray toward the
inside, being sure the cubber bumpers overlap
the top edge of the tray.
7. Install the four small rectangular plastic inserts
(#3) into the reinforcement bars under top tray.
Install the four large rectangular plastic inserts
(#8) into the four holes on the left and right
supports (#7 & #11).
You are now ready to use your Arcan Model AWT8019
Deluxe work table.
AWT8019 033109