User's Manual

ManualsBrandsArcher Wireless ManualsComputers & AccessoriesWireless Optical Mouse

Welcome

Thank you for purchasing this RF Wireless Optical Mouse. Utilizing

the latest wireless RF technology. This mouse can work from any

directions or angles even when objects hinder between your mouse &

the receiver. You can locate the device freely and enjoy its

convenience.

Install your wireless mouse

Hardware Installation

Installing batteries

1. remove the battery cover from the bottom of your mouse

2. Insert two AAA Alkaline batteries into the battery compartment.

3. Replace the cover carefully.

Once the battery is placed correctly in the mouse, the optical LED

located at the mouse bottom will light up.

z Once the battery is placed correctly in the mouse, the optical

LED located at the mouse bottom will light up.

Summary of content (5 pages)

PAGE 1
Welcome Thank you for purchasing this RF Wireless Optical Mouse. Utilizing the latest wireless RF technology. This mouse can work from any directions or angles even when objects hinder between your mouse & the receiver. You can locate the device freely and enjoy its convenience. Install your wireless mouse Hardware Installation Installing batteries 1. remove the battery cover from the bottom of your mouse 2. Insert two AAA Alkaline batteries into the battery compartment. 3. Replace the cover carefully.
PAGE 2
Connect the Mouse To connect to the USB port on PC (Windows 98 or higher is required) Connect the USB receiver to the USB port on the computer and wait for a while for hardware identification of mouse on the PC Press & release the button for ID setting (this procedure has to be made each time after re-insert battery). Power on-off function This ON/OFF function is designed to save battery life.
PAGE 3
Establishing a Communication Link 1. Press the ID button of your receiver and the LED of the receiver will flash quickly. 2. Press the ID button on the back of your mouse in 2 minutes then the LED of the receiver stop to flash 3. Once the receiver links with the mouse successfully, and then you can use it normally, if you move the mouse or press any key on the mouse the LED on the receiver will flash in accordance with.
PAGE 4
z Battery detection system and middle wheel indicator light warn you when the battery power is low and requires replacement. z Always use Alkaline batteries ONLY. Do not mix used and new batteries in one mouse. z When this RF Optical mouse is interfered by other RF mouse users, please reconnect the mouse receiver and link the communication again z For better performance, please use USB extension cable, and put the receiver on your desk if desktop PC is used. z Using light color mouse pad is recommended.
PAGE 5
Federal Communications Commission (FCC) Statement 15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. 15.105(b) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.