Specifications

Chalet 1800 Ins 10
Faceplate Installation
NOTE: There is 6” to 9” of adjustability between the back of the faceplate and the front of the flue col-
lar. The faceplate box will have all required hardware for installation.
1) Start the installation by remounting the 4 angle clips
into the predrilled holes in the top and bottom of each
side of the insert as shown. The faceplate will mount
flush with the surface it is covering. Take this into ac-
count when adjusting the 4 mounting brackets.
2) Remove the Faceplate and Louver assembly from the
packaging. From the back, screw the louvered section
to the top section of the faceplate as shown with 3 self
tap screws. (complete surround not shown)
Start by placing some form of protection on top of the insert top so that the surface will not be
scratched as you slide the faceplate and louvered section onto the top. The bottom left leg of the
faceplate has a notch that will slide over the air adjustment rod as shown below. Push the faceplate
back until it contacts the 4 installed brackets. Make sure that the faceplate is flush and even with the
area it is covering. Adjust the brackets as required. Remove the material used as protection and us-
ing 4 black supplied screws install the faceplate to the brackets. Left and right side as shown.
The faceplate will slide
past the rod. Install
the small coil handle
supplied with the door
assembly onto the
shaft
BRACKETS