Specifications

Chalet 1800 Ins 11
1. There are four screws used on fan mounting brackets left and right ,as shown below Re-
move the 2 screws on the side of the bracket.
2. Install the sensor bracket as shown with the 2 screws as shown below. If parts or servic-
ing is required please consult a professional to avoid injury. If the wires have been re-
moved from the sensor re-install them by matching the two female spade connector leads to
the two male tabs on the heat sensor as shown.
3.
Slide the fan module into place making sure that wires cords are not caught or pinched into
the fan or housing .Align the holes in the fan housing and insert brackets and install screws.
Call your dealer if you require assistance. Caution: The connection cord should not be
routed under or in front of the assembly and also kept away from any hot surfaces. Do not
route cord under or in front of unit.
BLOWER / FAN ASSEMBLY AND REMOVAL. (MODULE COMES PACKED IN FIREBOX )
The CHALET 1800 WOOD Fireplace Insert is certified for operation with or without the fan.
CAUTION: Do not plug in Fan Module until full Insert installation has been completed. If ser-
vicing is required or if you need parts contact your dealer or installer. To install or remove the
fan module follow these steps.
Electrical Rating = 120V AC / 1.0 amps
60hz
Fan Output Rating = 150 c.f.m.