Specifications

Chalet 1800 Ins 9
5. Attach spring handle by rotating the spring counter clockwise
onto the rod. Ensure that the spring screws onto the rod at least
½”.
6. After the handle is assembled, close the door and see how the
door closes. If it is too tight, turn the handle clockwise to loosen
it. If it is too loose, turn the handle counter clockwise to bring the
door closer to the insert body.
7. To verify that the doors are well sealed, insert a piece of paper
between the door and the insert body. You shouldn’t be able to
pull the paper out. Tighten it to the point where the paper is start-
ing to tear when you are pulling it out.
8. At this point take the lock nut and thread it onto the lock bolt and
thread the assembly into the hole provided just under the door
handle assembly and lock down the lock nut. This is to keep the
handle from turning.
9. Cover the holes with the two decorative plug buttons
The door comes assembled with the glass and gasket.
1. Run the threaded end of the handle
through the hole in the cast door.
2. Insert the clevis pin into the roller
3. Insert the end of the clevis pin and
roller assembly into the hole in the
end of the handle
4. Insert the cotter pin into the end of
the clevis pin to keep the assembly
from coming apart.
Cotter pin goes through
Clevis pin as shown
here
Roller
Clevis Pin
Cotter Pin
DOOR ASSEMBLY & INSTALLATION
Bolt &
Lock
Nut