Specifications

Optima 70 - 2 25
LOG PLACEMENT
WARNING:
Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this appliance may result in property damage or personal injury.
The Archgard “FiberFlame Technology Burner System” ceramic logs are designed to give a re-
alistic fire package, and are created to look the same as the day they were originally installed.
Care must be given when first installing the logs, and if removed for servicing, as they can be
damaged or broken if not handled properly.
After opening the log set package, inspect the logs to ensure that no damage has occurred in-
side the package. Please report any damage immediately to your Authorized Archgard Dealer.
Gas and vent connection must be made before installing the logs on the “FiberFlame” bed.
NOTE: Improper placement of logs may cause sooting on the internal parts and glass, and will
not be covered under warranty. Do not use broken or damaged logs.
NOTE: Installing the “FiberFlame” Ceramic logs in any other position other than shown will result in
flame impingement , causing sooting of the logs, brick liner and ceramic glass viewing area.
FiberFlame Burner Bed
Pre-formed log
locations
The ember bed is pre-formed to accept the first four “base” logs. Locate the first four base logs, and place
them on there perspective locations. Refer to the pictured instructions on the following pages that will
show how to place all 7 (seven) logs. The bottom of each log has a 4 digit code that can be used as a ref-
erence to help locate the correct log.
IMPORTANT: DO NOT PLACE ANY LOGS OVERTOP OF THE BURNER “PORTS”.