Installation Guide

Mounting and Use Instructions
Thank you for purchasing this premium locking mailbox. We know you'll be satisfied with the years of
service it will provide. If you have any questions about how to mount or use this mailbox, or if you need
any replacement parts, please call us directly at [phone] or contact us at
[e-mail].
[phone] www.architecturalmailboxes.com
© 2018, Architectural Mailboxes Rev I
Mounting your new mailbox
1
2
3
4
X 2
1/4" masonry bit
- or -
1/16" wood bit
X 2
Mount the mailbox under an eave or
other protected area. While holding the
opened box against the wall at the
desired location, mark the wall at the top
of each top mounting hole. Use a level
to make sure the box is positioned
correctly.
Drill into the wall at each marked location. Use
a 1/4" drill bit for brick or other masonry wall.
Use a 1/16" drill bit for wood wall.
For brick or other masonry wall,
insert a plastic anchor
(included) into each hole. Tap
in gently if necessary. This step
is not required if mounting on a
wood wall.
A) Mount the box temporarily using two screws
partially screwed into the top holes.
B) Mark the wall at the center of the two bottom holes
and remove the box by lifting and sliding it off the two
top screws.
C) Repeat steps 2 and 3 for the two bottom holes.
D) Securely remount the box using all 4 included
screws.
R
X 2