Installation Guide

Mounting and Use Instructions
Thank you for purchasing this premium locking mailbox. We know you'll be satisfied with the years of service it will provide.
If you have any questions about how to mount or use this mailbox, or if you need any replacement parts, please call us
directly at [phone] or contact us at [e-mail].
[phone] www.architecturalmailboxes.com © 2017, Architectural Mailboxes 2594 Rev C
Mounting your new mailbox
3
4
KEYS - Your new mailbox comes with two keys. The keys allow access to the
mail storage compartment. To retrieve incoming mail, simply open the access
door with the key.
CONVERTING TO NON-LOCKING VERSION - The locking door can be
removed if you want to convert your mailbox to a non-locking version. Unlock
the door and remove the small metal clips that hold the hinge pins on. You will
need some small pliers to do this.
Using your new mailbox
X 2
For brick or other masonry wall,
insert a plastic anchor
(included) into each hole. Tap
in gently if necessary. This step
is not required if mounting on a
wood wall.
A) Screw two of the included screws into holes almost
all the way, allowing enough space to slide the bottom
mailbox holes snugly over the screw heads.
B) While holding the mailbox against the wall, mark the
wall at the center of the two top holes, then remove the
box by lifting and sliding it off the two bottom screws.
C) Repeat steps 2 and 3 for the two top holes.
D) Remount the box by sliding it back onto the bottom
screws and securing it with the top screws.
R
2
X 2
1/4" masonry bit
- or -
1/16" wood bit
Drill into the wall at each marked location. Use
a 1/4" drill bit for brick or other masonry wall.
Use a 1/16" drill bit for wood wall.
1
Mount the mailbox under an eave or
other protected area. While holding
these instructions against the wall at the
desired location, mark the wall at the
center of each dot at the bottom of this
page. These marks represent the
bottom mailbox hole locations. Use a
level to make sure the page is
positioned correctly.
X 2
Use this guide to mark the bottom hole location - make sure the page is level before marking.