Installation Guide

4” cast brass address numbers

installation instructions

Manually screw the blunt ends of the included screws into

the back of the house number as shown in the figure.

Mark the wall at the desired

location using the number with

attached screws as a guide.

For wood walls, drill a 3/16” pilot hole at

each marked location.

For stone, concrete or stucco walls, drill a

5/16” hole to a depth of 1-1/2” at each

marked location and push the included

plastic anchors completely into the holes.

Manually push the number into the holes or anchors. If

necessary, gently pound the number into place being careful not

to damage the number surface.

Optional: Leave the screws partially out of the holes or anchors

for a floating number effect.

PAGE 1
4” cast brass address numbers installation instructions 1 Manually screw the blunt ends of the included screws into the back of the house number as shown in the figure. 2 3 Mark the wall at the desired location using the number with attached screws as a guide. For wood walls, drill a 3/16” pilot hole at each marked location. For stone, concrete or stucco walls, drill a 5/16” hole to a depth of 1-1/2” at each marked location and push the included plastic anchors completely into the holes.