Installation Guide

If you have any questions about how to install your hardware, please call us directly at [phone] or
[phone] (for outside of USA) or contact us at [e-mail].
Door Knocker Installation Instructions (Model 3660)
1/8” Drill bit
Power drill
Pencil
Level
© 2017, Architectural Mailboxes, LLC. Rev A
Parts and Hardware (included)
x2 wood screws
x1 hex key
backplate
set screw
knocker cover
knocker
Recommended tools (not included)
Using the hex key,
unscrew the set screw
to remove the knocker
and knocker cover.
Center the door
knocker backplate on
the exterior side of the
door at the desired
location, making sure it
is level. Then, mark the
center of the two holes.
Drill pilot holes at each
marked location, making
sure not to drill through
the door.
Mount the square
door knocker and
cover to the
backplate.
Secure with the
small set screw
and hex key.
Using the two wood
screws, secure the
door knocker back
plate to the door.
P: [phone] www.architecturalmailboxes.com
R
1
2
3
Tip: Mark the drill bit with
a marker or tape at about
1” from its end, then use
the mark as aguide to
make sure you don’t drill
through the door.