Instructions / Assembly

[phone] www.architecturalmailboxes.com
© 2018, Architectural Mailboxes 7510 Rev K
3
Attach the two halves of
the decorative post cover
to each other around the
post using the 4 tapping
screws. The cover will be
slightly loose so that it can
be raised during gardening
or lawn maintenance.
x4
Locate the correct height for the
support arm. According to USPS
requirments, the top surface of
the arm should rest from 41” to
45“ from the road surface. Refer
to the mailbox instructions for
more details.
Press the rubber pads into the
grooves of the support arm
pieces.
x6
6
Attach the finial to
the top of the post
using the 12mm
Phillips screws.
x2
Assembly Instructions
5
Attach the mailbox to the post
using the 4 large hex bolts
and 4 large washers.
Attach the mailbox to the post with 4
long Phillips screws.
If you are mounting a wider (T2 sized)
mailbox, insert a spacer in between the
mailbox and post arm at each of the
side hole locations.
Hardware (included)
Tools (not included)
Two open end wrenches Phillips head screwdriver
- or -
Thank you for purchase this premium mailbox post. We know you’ll be satisfied with the years of service it will provide. If you have any
questions about how to assemble or install this product, or if you need any replacement parts, please call us directly at [phone] or
contact us at [e-mail].
3” Round Mailbox Post with Cover and Finial (Model 7510)
Assembly Instructions
R
Then, attach the arm to the post using
the six 3/8” Phillips screws. Make sure
all screws are even and snug.
4a
4b
x 4
1a
Lay post pieces on a flat surface, making sure to align
the screw holes.
2
A concrete footing is
highly recommended for
cantilever style posts.
Install the assembled post
into the ground as described
in the instructions for the
mailbox. Typical post depths
range from 12”-18” and may
vary based on your
installation application. Pay
particular attention to the
location, height, and distance
from the street.
TO INSTALL USING
TOP MOUNTING HOLES
TO INSTALL USING
SIDE MOUNTING HOLES
To join the two post pieces:
x 3, large sheet metal screws
To join the two decorative covers:
x 4, tapping screws
x 6, 3/8” Phillips screws
To join the two support arm
pieces:
x 4, rubber pads
To attach the finial:
x 2, 12mm Phillips screws
To attach the mailbox using
the top mounting holes:
x 4, large hex bolts
x 4x large washers
To attach the mailbox using
the side mounting holes:
x 4, long Phillips screws
x 4, nylon spacers (optional)
1
3
4 5
6
1b
x4
x4
optional
x3
!
Join the two post pieces together using the 3 sheet
metal screws.
Tighten until snug.