Installation & Assembly

Page | 1

POLYURETHANE PANEL MOULDINGS INSTALLATION

TOOLS:

• Measuring tape

• Fine tooth saw & Mitre box or

compound mitre box

• Pencil

• Safety goggles

• Safety mask

• Hammer or finishing nailer

• Putty knife

• Caulking gun

• Paint brushes

• Level

MATERIALS:

• Nails

• Polyurethane Panel mouldings

• Premium Polyurethane

Construction adhesive

• High quality all Acrylic latex or oil

based paint

• Painters Caulk

• Clean cloth or sponge

• 220 grit sandpaper

SAFETY

Wear safety mask and goggles when cutting Polyurethane Panel mouldings.

WALL AND CEILING PREPARATION

Prior to installing panel mouldings make sure walls are

• dust free

• dry

• grease free

If needed, lightly sand and wipe surface with a damp cloth.

WORKING CONDITIONS

Before installing Architectural Products’s Polyurethane Panel mouldings,

make sure mouldings and adhesives are placed at room temperature 24

hours before installation. This allows material to adjust to the temperature

of the room to avoid expansion or contraction.

The recommended room temperature to install mouldings is between 50°

to 95° Fahrenheit

PAINTING

Mouldings can be painted either before installation or after. It is up to the

installer.

PAGE 1
POLYURETHANE PANEL MOULDINGS INSTALLATION TOOLS: • Measuring tape • Fine tooth saw & Mitre box or compound mitre box • Pencil • Safety goggles • Safety mask • Hammer or finishing nailer • Putty knife • Caulking gun • Paint brushes • Level MATERIALS: • Nails • Polyurethane Panel mouldings • Premium Polyurethane Construction adhesive • High quality all Acrylic latex or oil based paint • Painters Caulk • Clean cloth or sponge • 220 grit sandpaper SAFETY Wear safety mask and goggles when cutting Polyurethane
PAGE 2
Use a high quality Acrylic latex or Oil based paint. Mouldings are factory pre-primed and ready to paint or faux finish. MEASURING AND CUTTING Polyurethane Panel mouldings should be cut ¼” longer when filling a gap. It would spring into place. We recommend using a carbide saw blade with 80 (80T) or 120 (120T) teeth or more. If using a compound mitre box, follow the manufacturer’s instructions when mitering angles for inside or outside corners.