User Manual Part 1
MANUAL
V0.9
TV+
SCHEDULING A TV RECORDING > P. 69
For the “Channel” parameter, select the highest channel that is currently memo-
rized on your tuner.
Select the “
Test channel select” button. Make sure that your tuner is on. Your
ARCHOS device will then attempt to switch your tuner to the selected channel.
After a few seconds, your ARCHOS will ask you if the device responded correctly:
If this worked, select “
Yes”.
If this did not work, select “
No, try next option”. Your device will try again to
switch your tuner to the selected channel, using a different option*. Repeat this
operation until it works.
*Here is a description of the different parameters automatically set by the ARCHOS:
“Key Delay”:
delay between the emission of each digit of a channel (“Short”, “Normal”,
“
Long”).
“Key: Enter”:
Set to “On” if normally, you have to press an “OK” button on your turner’s re-
mote control after you enter the channel number. Example: If you normally press 1, 3, “
OK”
to access channel 13, then this parameter is set to “
On”.
“Key: -/--”:
Set to “On” if normally, you need to press a special key on your tuner’s remote
control before entering a channel with several digit numbers (that is to say a channel great-
er than 9). This key is often represented with this symbol: “-/--”.
“Switches on with”:
see below.
“Time until video”:
see below.
After you selected “Yes” at the end of the 2nd step, the following screen appears.
You will have to set these two parameters:
“Switches on with”: this depends on what key you normally press, on your
tuner’s remote control, to turn it on. If you normally press the “Power” key,
select “Power”. If you can press any channel key, then select “Any channel”. If
you can press any key, select “Any key”.
“
Time until video”: select the amount of time it normally takes between the
moment you turn on your tuner, and the moment the image appears on your
TV (“0...10 seconds”, “10...30 seconds”, “>30 seconds”).
1.
2.
-
-
-
-
-
3.
-
-