User's Manual

Connecting it to the TV Docking Pod

Plug the connector end of the Infrared Emitter to the far right jack on the back of the TV Docking Pod.

This emitter will act as your remote control for your scheduled recordings.

Sticking it onto your device and Setting the IR Emitter code

Now that you know where the infrared receptor is, you need to set the correct infrared emitter code on your

AV 700 TV and then afﬁ x the IR emitter to your device. Every VCR, cable box, and satellite receiver has a

different infrared code to tell it to turn on and off and how to change channels. With the IR emitter in one hand,

move it over the infrared receptor on your cable box, VCR, or satellite receiver and then set the infrared code as

explained in the section Setting the Infrared Emitter Code . Once you get the AV 700 TV to start controlling your

device by infrared signals (there are test buttons for this – see the TV Control setting for help), you can then peel

off the white ring protecting the adhesive, and stick the IR emitter to your device. If your regular remote control for

this device is sensitive to distances, you could afﬁ x the Infrared Emitter slightly to the left or right of the device’s

receptor so as not to impede the functioning of the regular remote control.

23.1.3 Connection Diagram

Cable Box, Satellite Receiver

or Video Cassette Recorder

Antenna

Satellite

Dish

Cable

(1) You can use the S-Video output instead of the composite yellow.

You will need to purchase a standard S-Video cable for this.

(2) See the manual section on connecting the infrared emitter.

(3) You can use the AV connections on the front or back of your television.