User Manual

User's Manual
13
&S0 DSR override (is assumed to be ON all the time)
&S1 DSR follows circuit definition
Result codes:
OK n=0 or 1
Error Otherwise
Related S-Reg: S64
&V Display Active profile, Stored Profiles, Stored Phone Numbers (Equivalent to I4-I7 combined)
&Wn Writes current configuration
&W0 Write to template 0
&W1 Write to template 1
Result codes:
OK n=0-1
Error Otherwise
Written to registry.
&Zn Stores dial string
Stores/Displays dial string (up to 47 characters)
&Zn=s Store dial string (n=0-4)
&Zn=L Store the last dialed string (n=0-4)
&Zn? Display the nth string
&ZL? Display the last dialed string
Written to registry.
AT\ Commands - Error correction control
\An
*
Maximum MNP block Size
\A0 64 characters maximum block size
\A1 128 characters maximum block size
\A2 192 characters maximum block size
\A3 256 characters maximum block size
Result codes:
OK n=0-3
Error Otherwise
Related S-Reg: S<basereg+1> of V.42 registers
\Bn Transmit break to remote (-)
In non-error correction mode, the modem will transmit a break signal to the remote modem with
a length of n*100ms. If a number above 9 is entered, 9 is used.
Result codes:
OK if connected in data modem mode
Error if not connected or if connected in fax modem mode
\Kn Break Control (-)
Controls the response of the modem to a break received from DTE or a remote modem or the
\Bn command.
The behavior parameter is written to Sxx
\K0 Enter on-line command mode, no break sent to remote modem
\K1 Clear data buffers and send break to remote modem