User Manual

User's Manual
23
S# Function Range Units PW Default AT Command
S0 Rings to Auto-Answer 0-255 rings 0
A
S1 Ring Counter 0-255 rings 0
S2 Escape Character 0-255 ASCII 43
S3 CR Character 0-255 ASCII 13
S4 LF Character 0-255 ASCII 10
S5 BS Character 0-255 ASCII 8
S6 Wait Time for Dial Tone
(Also wait before Blind Dialing)
2-255 s * 2
D
S7 Wait Time for Carrier 1-255 s * 60
D
S8 Pause Time for Dial (,) 0-255 s 2
D
S9 Carrier Detect Response Time 1-255 0.1s 6
S10 Carrier Loss Disconnect Time 1-255 0.1s * 7
S11 DTMF Tone duration 50-255 0.001s * 100
D
S12 Reserved
S13 Echo 0-1 1
E
S14 Quiet 0-1 0
Q
S15 Verbose 0-1 1
V
S16 Pulse/ Tone 0-1 * 1
T,P,D
S17 Reserved
S18 Test Timer 0-255 s 0
&T
S19 System Inactivity Timer 0-255 min 0
S20 Reserved
S21 Break Length 0-9 100ms 9
\B
S22 Origin/Answer 0-1 0
S23 XOFF Character (NA) 0-127 ASCII 19
S24 Flash Timer 0-255 10 ms 20
Important Note: The following S-register List is only to be used by OEMs.
For end users, the contents of the first 24 S-registers should suffice.
S# Function Range Units PW Default AT Command
S25 Delay to DTR Off (NA) 0-255 0.01ms 5
S26 RTS to CTS delay (NA) 0-255 0.01ms 1
S27 Auto Answer clear timeout 0-255 s 8
S28 Pulse Set/Break Ratio 0-4 0
&P,P,D
S29 Speaker Control 0-3 1
M
S30 Speaker Volume 0-3 2
L
S31 Automode Select 0-1 1
+MS
S33 Requested MIN Speed bps
Code
+MS
S34 Requested MAX Speed bps
Code
+MS
S35 Actual Speed after CONNECT
(See Xn )
bps
Code
S36 Current Data Pump Status Mod
Code