User Manual

User's Manual
26
S# Function Range Units PW Default AT Command
S194-
S196
Reserved 2
S197 HW Diag
S198 STRM Diag 0/1 0
*B
S199 Port Diag 0/1 0
*B
S200 Blacklist Enable 0/1 * 0
*B
S201 Blacklist Dial Attempts 0-255 * 5
*B
S202 Min Time between calls 0-255 Sec * 5
*B
S203 Blacklist Time Out 0/1 * 0
*B
FCC Notice
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures :
l Reorient of relocate the receiving antenna.
l Increase the separation between the equipment and receiver.
l Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
l Consult the dealer or an experienced radio / TV technician for help.
This unit was tested with shielded cables on the peripheral devices. Shielded cables must be
used with the unit to insure compliance. This statement can be deleted if unit was not tested
with shielded cables.
The manufacture is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate
the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
condition:(1) This device may not cause harmful interference, and (2) This device must
accept any interference that may cause undesired operation.
FCC Requirement
This equipment complies with Part 68 of the FCC Rules. On the base unit of this equipment
is a label that contains, among other information, the FCC Registration Number and Ringer
Equivalence Number(REN) for this equipment. If requested, this information must be given
to telephone company.
The REN is useful to determine the quantity of devices you may connect to your telephone
line and still have all of those devices ring when your telephone number is called. In most,
but not all area, the sum of the REN's of all devices connected to one line should not exceed