User Manual

User's Manual
7
On Returns to on-line data mode
This command is normally used to connect the DTE back after an escape (+++) has been issued.
O0 Return to on-line data mode.
O1 Return to on-line data mode, retrain first.
Result codes:
OK n=0-1
Error Otherwise
P Pulse dialing
Forces pulse dialing. Applies to subsequent dialing commands.
This command holds until the next T dial modifier or T command is received.
The modem will go off hook and attempt to answer an incoming call. Upon successful
completion of handshake, the modem will go on-line in answer mode.
Related S-Reg: S16
Q
*
Quiet result codes control
Q0 Enable sending result codes to DTE.
Q1 Disable sending result codes to DTE.
Result codes:
OK n=0 or 1
Error Otherwise
Related S-Reg: S14
S Read/Write S-Register
This command has a few derivatives:
Sn=v Sets the value v (decimal) to S-register n (v=0-255)
Sn? Displays the value of S-register in decimal format (3 digits)
Note: Some registers are read-only
Result codes:
OK All parameters valid
Error Invalid S register or value. Trying to write to a read-only register
T Tone dialing
Forces tone dialing. Applies to subsequent dialing commands.
This command holds until the next T dial modifier or T command is received.
This command changes S14 to reflect the current dialing mode.
Related S-Reg: S16
Vn
*
Verbose/Numeric result codes
Select the time of result messages sent to the DTE.
For a list of result codes and verbal messages see X command.
V0 Short form (numeric) result codes to be sent to DTE.
V1 Long form (verbose) result codes to be sent to DTE.
Result codes:
OK n=0 or 1
Error otherwise
Related S-Reg: S15