User Manual

User's Manual
8
Xn Extended result codes
Select the subset of result codes to be used by the modem to the DTE.
If the modem is in fax mode (+FCLASS=1), the only message sent to indicate connection is
“CONNECT” without a speed indication.
X0 Supported messages: OK, CONNECT, RING, NO CARRIER and ERROR, Blind call
enabled.
X1 Supported messages: OK, CONNECT xxxx, RING, NO CARRIER and ERROR, Blind
call enabled.
X2 Same as X1 + NO DIAL TONE message, Blind call disabled
X3 Same as X1 + BUSY message, Blind call enabled.
* X4 All messages supported, Blind call disabled (see list below).
Notes:
W,@ dial modifiers are ignored in X1, X2
S6 (Wait before dial) is ignored in X2, X4 if no W is specified in dial string
S6 is set to 0 means a blind call
Table 1 - Result Codes
Result Message X0 X1 X2 X3 X4
Code
0 OK * * * * *
1 CONNECT * * * * *
2 RING * * * * *
3 NO CARRIER * * * * *
4 ERROR * * * * *
5 CONNECT 1200 1 * * * *
6 NO DIAL TONE 3 3 * 3 *
7 BUSY 3 3 3 * *
8 NO ANSWER 3 3 3 * *
9 CONNECT 0300 1 * * * *
10 CONNECT 0600 1 * * * *
11 CONNECT 2400 1 * * * *
12 CONNECT 4800 1 * * * *
13 CONNECT 7200 1 * * * *
27 CONNECT 9600 1 * * * *
14 CONNECT 12000 1 * * * *
15 CONNECT 14400 1 * * * *
16 CONNECT 16800 1 * * * *
17 CONNECT 19200 1 * * * *
18 CONNECT 21600 1 * * * *
19 CONNECT 24000 1 * * * *
20 CONNECT 26400 1 * * * *
21 CONNECT 28800 1 * * * *
22 CONNECT 31200 1 * * * *
23 CONNECT 33600 1 * * * *
24 CONNECT 34800 1 * * * *