Installation manual

Photoelectric Safety Cell (240 volt & 12 volt operators only
A photoelectric safety cell (PE) may be fitted to detect obstructions in the path of the gate(s).
The PE will check for obstructions during the closing cycle only. If an obstruction is
encountered the gate(s) will reverse to the open position.
If the gate is set in the automatic close mode the gate(s) will remain open until the
obstruction is cleared.
Wires from the PE should be attached to the appropriate connection block. (See figure 9)
Note: Extra power consumption will occur when using Photoelectric Cells so extra panel(s)
and battery(s) will be required when gate(s) are operating on solar power only.
LI-2B Installation Manual