Installation Guide

Table Of Contents

These products should be located and mounted to a wall.

While it is possible to mount them to any surface, a stud or concrete mounted product will yield the best results.

These products are not designed or intended for use as a grab bar or support bar. Do not install any of these

products in any area where they are likelyto be used inadvertenrly as a grab bar or support bar.

To preserve the fine finish of this product, clean only with a soft

damp cloth. Dry well. Do not use commercial or abrasive cleaners.

Cleaning Instructions:

NOTE:

DANGER:(Risk of personal injury)

unit:inch(mm)

4050301

Towel rack

Front

Back

Put the screw (1) through the plate (2)

from back side,

tigten the plate (2) and towel bar (3)

with the screw (1).

Back

24"(607)

22"(557)

11.4"(290)

12.6"(320)

5.2"(133)

3.6"

(92)

2.3"

(57)

4.7"(120)

Select a location on the verticalwall to

install the bracket.

Mark anchor mounting hole locations on

wall as shown , ensure four screw holes

are horizontal.

Drill holes in the ﬁnished wall as required.

1.Press the anchors (5) into the holes.

2.Put the self-tapping screw (2) through

the button seat (3),

3.secure the bracket (4) with the

self-tapping screws (2).

4.Buckle up the button (1)

PAGE 1
Towel rack unit:inch(mm) 4050301 24"(607) 3.6" (92) 2.3" (57) 4.7"(120) 4.7"(120) 5.2"(133) 11.4"(290) 12.6"(320) 22"(557) Front Back 2 3 Back 1 Put the screw (1) through the plate (2) from back side, tigten the plate (2) and towel bar (3) with the screw (1). 5 1 2 3 4 Select a location on the verticalwall to install the bracket. Mark anchor mounting hole locations on wall as shown , ensure four screw holes are horizontal. Drill holes in the ﬁnished wall as required. 1.
PAGE 2
Towel rack unit:inch(mm) 4050201 24"(607) 5.2" (133) 3.6" (92) 4.7"(120) 4.7"(120) 8"(202) 11.4"(290) 12.6"(320) 22"(557) Front Back 2 3 Back 1 Put the screw (1) through the plate (2) from back side, tigten the plate (2) and towel bar (3) with the screw (1). 5 1 2 3 4 Select a location on the verticalwall to install the bracket. Mark anchor mounting hole locations on wall as shown , ensure four screw holes are horizontal. Drill holes in the ﬁnished wall as required. 1.