Installation Guide

1.Use the triangle fastener(15)
when the thickness of sink <5mm.
2.Place Triangle fastener（15）
and washer(4) and metal plate(5)
over mounting stud(3) under sink.
Secure with mounting nut(6),
tighten the screws(7) to fix the
faucet body.
3.Attach supply hot(8)and cool
lines(9) .
4. If the anglve is G1/2'', please
use G3/8'' standard pipe connection
G1/2'' adapter included (10) .
Do not overtighten. Turn water
back on.
1. turn faucet handles to the full on
mixed position.
2.Turn on the button.
3.Turn on hot and cold water supplies
and flush water lines for one minute.
Important: This flushes away any
debristhat could cause damage to
internal parts.
Verify theseal is attached to aerator
then reinstall.
Check all connections for leaks.
Re-tighten if necessary, but do not
overtighten.
5
6
3
4
7
15
8
1
3.B
4 5
Before installing the valves,
clean the water pipe thoroughly
to avoid dirt and deposits.
1
1
3
1.Make sure fasten the thread
pipe(3) to the base of the
faucet body clock-wise.
2
3.A
1. Make sure
attach the
O-ring(2) to
the faucet body.
2.Slide 9.6" decorated
plate with gasket(3) up over tubes
and mounting stud.
Slide tubes down through mounting
hole and faucet, 9.6"decorated
plate with gasket on sink.
1. Make sure
attach the O-ring(2) to the faucet body.
2.Slide tubes down through mounting
hole andfaucet on sink.
Option: If sink is uneven, use silicone
under the gasket.
Attach flexible
hoses under the faucet body.
9
10
or
2
1
2
1
3
o
n
o
ff
o
n
o
n
o
n
Turn on the faucet
Spray
Turn on the faucet
Standard Flow
Aerator
Turn on the faucet
Standard Flow
Aerator and Spray