gijwuda6q6xlqrjww29n

InstallatIon & MaIntenance InstructIons for
rectangular and custoM covers
INSTALLING A RECTANGULAR COVER
PLEASE NOTE: If a cover is going to be anchored into a raised bond beam, spa wall,
waterfall, etc., proceed to the instructions on the top of the reverse side.
STEP 1
Inspect the area 3’ back from the water’s edge around the entire pool. Remove any irregular
obstructions that may protrude through the cover. Pad rough coping, sharp edges, and inside
corners with carpet, foam or similar material. Excessive wear due to non-padded areas is
specically excluded from the warranty.
STEP 2
Measure exact dimensions of swimming pool and cover. From the difference between these
measurements, adjust the overlap so that it is equal at all corners of the pool. Though
standard overlaps on stock covers are 12” and custom covers 15”-18”, they may vary
several inches either way.
STEP 3
Measure 22” from corner in each direction and locate position point (A) of anchors for all
four corners.
STEP 4
Install the 8 anchors at the 4 corners and step section if applicable. (see Anchor Installation
on reverse side). Attach at shaped side of springs to corner straps (see spring attached to
cover for proper spring attachment). Next, install the springs on anchors using the Installation
Rod (see Cover Installation on reverse side). Adjust buckles so that springs will compress
about 60-70% for a taut t.
STEP 5
Once the corners are secured, install remaining anchors 22” from the cover’s edge in line
with each strap. Make certain the same overlap is maintained as in the corners and that the
straps are at a 90 degree, right angle, to the cover’s edge. Adhere to right angles, or bulges
and/or gaps will occur.
INSTALLING A CUSTOM COVER
PLEASE NOTE: If a cover is going to be anchored into a raised bond beam, spa wall,
waterfall, etc., proceed to the instructions on the top of the reverse side.
STEP 1
See Step 1 instructions for “INSTALLING A RECTANGULAR COVER”.
STEP 2
Measure exact dimensions of swimming pool and cover. From the difference between these
measurements, adjust the overlap so that it is equal at all locations of the pool. Though
standard custom cover overlaps are 15”-18”, they may vary several inches either way.
STEP 3
Locate anchor positions on Figure 1. Begin with strap location (A) and measure 22” from
cover. Mark this location on the deck. Continue for straps (B), (C), & (D).
STEP 4
Install the anchors for (A), (B), (C) & (D) (see Anchor Installation on inside of directions).
Attach at shaped side of spring to cover straps (see the spring attached to cover for proper
spring attachment). Next, install the springs on anchors using the installation rod (see Cover
Installation). Adjust the buckles so that springs will compress about 60-70% for a taut t.
STEP 5
Continue with installing straps and anchors (E), (F), (G) & (H) as indicated in Figure 1.
STEP 6
After completing the initial installation of the rst 8 anchors, install the remaining anchors
working from the center of the cover to the ends. Remember to alternate sides and to
attach and secure each spring to the cover as each anchor is installed.
IMPORTANT: Solid covers must be adjusted after installation to ensure that water does not collect on top of cover. After installation, ood cover with water. If standing water
forms puddles that do not drain, simply loosen strap on either side of the drain and tighten straps in the areas with standing water.
safetY cover sYsteMs
IMPORTANT: Do not drag cover on pool deck or any rough surface. Dragging cover on rough surface will cause scuffing, abrasions and/or holes.
Damage due to dragging cover on rough surface is specifically excluded from cover warranty.