gijwuda6q6xlqrjww29n
ANCHOR INSTALLATION
STEP 1
Install brass anchors by drilling 3/4” diameter holes to
a depth of 2”. Bevel or ream the top of the hole for
flush fit.
Remove anchor screw from casing. Spray anchor, screw
casing and aluminum tamping tool with silicone.
STEP 2
Insert tamping tool and tap the retainer into place.
Then insert the anchor screw using the hex key.
BRASS ANCHOR
COVER INSTALLATION
Insert the installation rod through rounded end of
spring. (Diagram A)
Place heel of rod behind raised anchor. Slip spring over
anchor by moving handle away from the pool wall. Step
down on spring. Remove installation rod by rotating 180
degrees and cover is then installed. (Diagram B)
COVER REMOVAL
Insert installation rod over anchor with notch away
from pool. (Diagram C) Next, press down and
rotate 180 degrees. Heel of rod will force spring
free of anchor. Tilt rod to release spring (Diagram
D)
• The springs should be very taut upon initial installation. In time, the cover will relax
and the tension will ease.
• The cover is designed to screen out leaves and other debris. Clear water can only be
maintained if proper levels of chlorine and algaecide are maintained.
• Be sure not to drop the pool’s water level more than 18” from top of pool during
winter months. Failure to do so will place undue strain on the cover and void the
warranty.
Debris may be easily hosed off a properly installed cover.•
Removal and subsequent installation is made easier if the cover is fan-folded.•
• Store the cover in the mesh storage bag included. Hang the bag off the oor so the
cover can drain.
• Flush out anchor casings with a hose several times a year to prevent sticking.
Spray anchor and casing with silicone.
• For solid cover owners: To clean the debris screen, remove cover, open and fold
back the mesh panel on top of the cover. Hose the lter screen off from behind to
remove ne debris. Close panel and store.
• FOR SOLID COVERS: Cover must be suspended above the pool’s water level in order
to drain. Excessive melting snow and spring rain can raise the pool’s water level too
high for cover to drain. If this occurs, simply drain some water from the pool until
the cover is suspended above the pool’s water level. Be sure not to drop the pool’s
water level more than 18” from the top of pool. Straps and springs may need
tightened to achieve proper tension.
CARE AND MAINTENANCE