Operator`s manual
56
B. Press and hold Set/Reset Button (4)
until minutes stop scrolling and the
hour display starts to scroll.
Momentarily release when correct
hour is displayed; then repeatedly
press and release Set/Reset Button
until correct minutes are displayed.
NOTE: Approximately two seconds
after releasing either Button, the
LCD will return to normal operation.
NOTE: Clock memory power is
supplied through the 15-amp acces-
sory fuse and verified during gauge
“power-up” and reset. In the event of
clock memory power failure (blown
fuse, etc.), the gauge will “power-
up,” reset, and shut down repeatedly
until clock memory power is
restored. Always check the 15-amp
accessory fuse if this gauge condi-
tion is noted.
NOTE: The engine hour meter will
not activate until engine speed
exceeds 500 RPM.
6. Gear Position Indicator - Indicates
which gear is selected - R (reverse)/N
(neutral)/H (high range)/L (low
range)/P (park).
NOTE: An E will be displayed if
there is an error caused by a no-shift
position signal.
7. Engine Hour Meter Indicator - Indi-
cates engine hour meter mode is
selected on the display.
8. Speedometer/Tachometer Indicator -
Indicates which mode (MPH, km/h,
or RPM) is being displayed.
9. 4WD Lock Indicator - Displays
LOCK when the front differential
lock has been engaged.
10. Drive Select Indicator - Displays
4WD when selected by the drive
select switch or when the 4WD lock
is engaged. The display is blank when
in 2WD.
11. High Beam Indicator - Appears when
the headlights are on high beam.
12. Temperature Indicator - The speedom-
eter/tachometer needle will sweep full
scale and the LCD will go blank except
the high temperature icon will flash.
After 30 seconds, the speedometer/
tachometer needle and LCD will return
to normal, but the temperature icon will
continue to flash. The icon should not
be visible during normal operation.
NOTE: High engine RPM, low vehi-
cle speed, or heavy load can raise
engine temperature. Decreasing
engine RPM, reducing load, and
selecting an appropriate transmis-
sion gear can lower the temperature.
NOTE: Debris in front of the engine
(or packed between the cooling fins of
the radiator) can reduce cooling
capacity. Using a garden hose, wash
the radiator and the engine to remove
any debris restricting air flow.
13. Odometer/Trip Meter Indicator Dis-
play - Displays which function (ODO,
Trip, or Trip 2) is selected.
14. Speedometer/Tachometer Needle
(digital/analog gauge) - Indicates
approximate vehicle speed in MPH or
km/h when speedometer function is
selected or RPM when tachometer
function is selected. Sweeps full-scale
whenever an EFI system error is
detected.
Wrench Indicator (digital gauge) -
Displayed in conjunction with a DTC
whenever an EFI system error is
detected.
CAUTION
Continued operation with high engine
temperature may result in engine
damage or premature wear.
CAUTION
Arctic Cat does not recommend
using a pressure washer to clean the
radiator core. The pressure may bend
or flatten the fins causing restricted
air flow, and electrical components
on the radiator could be damaged.
Use only a garden hose with spray
nozzle at normal tap pressure.