Operator`s manual

57
Electric Fuel Pump
An electric fuel pump is incorporated in
the gas tank to deliver gasoline to the fuel
injector. The fuel pump is activated when
the ignition switch is in the ON position.
 NOTE: Both the ignition and fuel
pump functions will be interrupted by
the Tilt Sensor if the ATV tips over
past 60°-70°. Righting the ATV will
reactivate the ignition and fuel pump.
Vacuum Fuel Pump
(400)
A vacuum fuel pump is mounted under
the seat to deliver gasoline to the carbure-
tor. The fuel pump operates when the
engine is turning.
Primer (400)
CF123A
The primer is located on the carburetor.
Depress and release the lever several times
prior to attempting to start a cold engine.
1. Remove the rear seat; then remove
the front seat.
2. Remove the right-side heat shield.
 NOTE: The heat shield can be
removed after seat removal by
pulling outward at the top to disen-
gage the mounting lugs from the
rubber grommets.
CF237A
3. Pump the primer as recommended;
then install the heat shield, front
seat, and rear seat making sure the
seats lock securely.
CF123A
Gas/Vent Hoses (400)
Replace the gas/vent hoses every two
years. Damage from aging may not
always be visible. Do not bend or
obstruct the routing of the carburetor vent
hose. Make certain that the vent hose is
securely connected to the carburetor and
hose holder and the opposite end is
always open.
Carburetor Float Bowl
Drain (400)
AF925
Periodically, the float bowl should be
drained to remove condensation. To drain
the float bowl, use the following procedure.