Operator`s manual

58
1. Direct the float bowl drain hose into a
container.
2. Loosen the drain screw and allow the
gasoline and condensation to flow out.
3. Tighten the drain screw securely.
Oil Level Stick
There is an oil level stick for checking
the engine oil level. To check the oil
level, use the following procedure.
 NOTE: The ATV should be on
level ground when checking the
engine oil level.
1. Unscrew the oil level stick and wipe
it with a clean cloth.
2. Install the oil level stick and thread it
completely into the engine case.
3. Remove the oil level stick; the engine
oil level should be within the operat-
ing range but not above the FULL
mark.
GZ461A
Windshied (Limited)
To remove the windshield, loosen the left and
right plastic knobs and remove the wind-
shield assembly. Tighten the knobs securely
or remove them completely to prevent loss.
CR003
To install the windshield, loosen the left
and right plastic knobs; then install the
tapered windshield pins into the mounts
and tighten knobs securely.
Mirrors (Limited)
The mirrors can be adjusted to the desired
viewing angle or moved to a stowed posi-
tion when operating in trees or brush.
Rear Seat Lock
1. To remove the rear seat, pull the two
latch handles to the rear and rotate
them to the vertical position.
CR017D
! WARNING
Do not drain float bowl contents
directly onto the engine. Gasoline is
highly flammable and could ignite.
Use a hose.
! WARNING
It is very important that the drain
screw be tightened securely. If it is
not tightened securely, gasoline
could drip onto the engine.
CAUTION
Do not overfill the engine with oil.
Always make sure the oil level is
within the operating range.
CAUTION
Remove the windshield before traile-
ring the ATV or damage to the wind-
shield may occur.
! WARNING
Always adjust the mirrors to a position
that will not catch tree branches or
under-brush which could cause a loss
of control and severe injury or death.