Operator`s manual
54
1. Loosen the jam nut.
2. Turn the throttle limiter screw
clockwise to decrease engine RPM
maximum or counterclockwise to
increase engine RPM maximum.
3. Tighten the jam nut securely.
NOTE: The ATV is equipped with
an RPM limiter that retards ignition
timing when maximum RPM is
approached. When the RPM lim-
iter is activated, it could be misin-
terpreted as a high-speed misfire.
Auxiliary Brake Pedal
CF117
Pressing the auxiliary brake pedal
downward will apply the brake to the
rear wheels.
SPEEDOMETER/LCD
(Digital)
NOTE: All segments of the LCD
will activate for approximately two
seconds when the ignition switch
is rotated to the ON position.
CF236A
1. Clock/Engine Hour Meter - The
clock function indicates time in the
12-hour mode; the hour meter
indicates the total time the ATV
has run and cannot be reset to zero.
To set the clock, use the following
procedure.
A. With the ignition switch ON,
press and release the Mode
Button (3) until the Clock/
Engine Hour Meter (1) is dis-
played; then (if necessary)
press and release the Set/Reset
Button (4) to select the clock
display.
B. Press and hold the Set/Reset
Button (4) until the minutes
stop scrolling and the hour dis-
play starts to scroll. Momen-
tarily release when the correct
hour is displayed; then repeat-
edly press and release the Set/
Reset Button (4) until the cor-
rect minutes are displayed.
NOTE: Clock memory power is
supplied through the 15-amp
accessory fuse and verified during
gauge “power-up” and reset. In the
event of clock memory power fail-
ure (blown fuse, etc.), the gauge
will “power-up,” reset, and shut
down repeatedly until clock mem-
ory power is restored. Always
check the 15-amp accessory fuse
if this gauge condition is noted.
NOTE: The engine hour meter
will not activate until engine speed
exceeds 500 RPM.
2. Temperature Indicator - If the
engine coolant temperature
exceeds the normal operating
range, the temperature icon will
begin flashing and the LCD will
go blank for 30 seconds; then the
LCD will return to normal. How-
ever, the temperature icon will
continue to flash.