Operator`s manual

69
GENERAL MAINTENANCE
4. Using the oil filter wrench and a
ratchet handle (or a socket or box-
end wrench), remove the old oil
filter and dispose of properly. Do
not re-use oil filter.

NOTE: Clean up any excess oil
after removing the filter.
5. Apply oil to the new filter O-ring
and check to make sure it is posi-
tioned correctly; then install the
new oil filter. Tighten securely.
6. Install the engine drain plug and
tighten it securely. Pour the recom-
mended oil in the filler hole.
Install the level stick.
7. Start the engine (while the ATV is
outside on level ground) and allow
it to idle for a few minutes.
8. Turn the engine off and wait
approximately one minute.
Recheck the oil level.
9. Inspect the area around the drain
plug and oil filter for leaks.
Front Differential And
Rear Drive Gear
Lubricant (Inspecting/
Changing)
Inspect and change the gear lubricant in
each according to the Maintenance
Schedule. When changing the lubricant,
use approved SAE 80W-90 hypoid oil
and use the following procedure.
1. Place the ATV on level ground.
2. Remove each oil filler plug.
3. Drain the oil into a drain pan by
removing in turn the drain plug
from each.
CF107B
CF106C
4. After all the oil has been drained,
install the drain plugs and tighten
securely.
5. Pour recommended oil into each
filler hole.
CF113A
CAUTION
Inspect the oil for any signs of metal
filings or water. If found, take the
ATV to an authorized Arctic Cat ATV
dealer for servicing.