Use and Care Manual

Operating Instructions
Control Panel Features
Auto
Heat
Wireless
MODE button
Selects the appropriate operating mode. Each
time you press the button, a mode is selected in a
sequence that goes from COOL, FAN, DRY, HEAT
(on some models), and AUTO(on some models).
The mode indicator light illuminates under the
different mode setting.
NOTE: On above modes, the unit operates the auto
fan speed automatically.
Used to adjust (increasing/decreasing) temperature
settings in 1°C/2°F(or 1°F) increments in a range of
17°C/62°F to 30°C/88°F (or 86°F).
NOTE: The control is capable of displaying
temperature in degrees Fahrenheit or degrees
Celsius. To convert from one to the other, press and
hold the Up and Down buttons at the same time for
3 seconds.
Up (+) and Down (-) buttons
Power button
Power switch on/off.
Power
indicator light
Timer mode
indicator light
(set only by
remote controller)
LED display
Shows the set temperature while on
cool,heat or auto mode. While on DRY
and FAN modes, it shows the room
temperature. Shows Error codes:
E0-EEPROM error.
E1-Room temperature sensor error.
E2-Evaporator temperature sensor error.
E3-Condenser temperature sensor error
(on some models).
E4-Display panel communication error.
EC-Refrigerant leakage detection
malfunction(on some models).
Shows protection code:
P1-Bottom tray is full--Connect the drain
hose and drain the collected water away.
If protection repeats,call for service.
NOTE: When one of the above malfunctions
occurs, turn off the unit, and check for any
obstructions. Restart the unit, if the
malfunction is still present, turn off the unit
and unplug the power cord. Contact the
manufacturer or its service agents or a
similar qualified person for service.
NOTE: The following control panels are for explanation purpose only. The control panel of the unit you
purchased may be slightly different according to the models. Your machine may not contain some indicators or
buttons. The actual shape shall prevail.

Page 18

Operating
Instructions