User Manual

FOLLOW ME/TEMP SENSING
Feature (optional)
Other Features
NOTE
This feature can be activated from the remote control ONLY. The remote control serves
as a remote thermostat allowing for the precise temperature control at its location.
NOTE
On some models the louver can be adjusted manually only):
• When the Power is ON, the louv
er opens fully.
• Press the SWING button on the panel or remote controller to initiate the Auto
Swing feature. The louver will swing up and down automatically.
• Please do not adjust the louver manually.
To activate the Follow Me/Temp Sensing feature, point the remote control towards
the unit and press the Follow Me/Temp Sensing button. The remote display is actual
temperature at its location. The remote control will send this signal to the air conditioner
every 3 minutes interval until press the Follow Me/Temp Sensing button again. If the unit
does not receive the Follow Me/Temp Sensing signal during any 7 minutes interval, the
unit will beep to indicate the Follow Me/Temp Sensing mode has ended.
AUTO-RESTART
If the unit shuts off unexpectedly due to a power outage, it will restart with the
previously set function automatically when the power resumes.
WAIT 3 MINUTES BEFORE RESUMING OPERATION
After the unit has stopped, it cannot be restarted until 3 minutes time has elapsed.
This is to protect the unit. Operation will automatically resume after 3 minutes.
AIRFLOW DIRECTION ADJUSTMENT
The louver can be adjusted automatically. Adjust the airflow direction automatically.
Water drainage
• During dehumidifying modes, remove the upper
drain plug from the back of the unit and install the
drain connector (5/8” universal female mender) with
3/4” hose (locally purchased). For models without
drain connector, just attach the drain hose to the
hole. Place the open end of the hose directly over
the drain area in your basement floor.
6&$/(
Remove
the upper
drain plug
¥
Continuous
drain hose
Operating
Instructions
Page 10