User Manual

NOTE
When one of the above malfunctions
occurs, turn off the unit and check
for any obstructions. Restart the
Unit. If the malfunction persists, turn
off the unit and unplug the power
cord. Contact the manufacturer or its
service agents or a similar qualified
person for service.
Operating
Instructions
Auto
Timer
Swing
Control
Power
Button
LED Display
Sleep
Mode
Fan
Speed
Up (+) and
Down (-) Control
Mode
Selector
LED display
Shows the set temperature in °C or °F
and the Auto-timer settings. While on
DRY and FAN modes, it shows the room
temperature.
Shows Error codes and protection code:
E1 - Room temperature sensor error.
E2 - Evaporator temperature sensor error.
E3 - Condenser temperature sensor error
(select models).
E4 - Display panel communication error.
P1 - Bottom tray is full -- Connect the
drain hose and drain the collected
water away. If protection code
repeats, call for service.
Control Panel Features (cont.)
Follow me
• Used to initiate the Wireless function. For
the first time to use Wireless function,
press and hold the swing button for 3
seconds to initiate the Wireless
connection mode. The LED DISPLAY
shows 'AP' to indicate you can set
Wireless connection. If connection(router)
is successful within 8 minutes, the unit will
exit Wireless connection mode
automatically and the Wireless indicator
illuminates. If connection is failure within 8
minutes, the unit exits Wireless connection
mode automatically. After Wireless
connection is successful, you can press and
hold SWING and DOWN (-) buttons at the
same time for 3 seconds to turn off Wireless
function and the LED DISPLAY shows 'OF'
for 3 seconds, press SWING and UP(+)
buttons at the same time to turn on Wireless
function and the LED DISPLAY shows 'ON'
for 3 seconds.
NOTE: When you restart the Wireless
function, it may take a period of time to
connect to the network automatically.
Wireless button
CONSTANT FAN(Press 3s)
Page 8