Specifications

WARNING: Fill the spa with water before turning on the power.

Once your spa has been ﬁlled with water, turn it on and test all of the circuit breakers.

NOTE: If the RCD breaker trips immediately, verify that the BLUE neutral wire is connected

into the load neutral in the breaker. Each breaker should be tested prior to each use. Here’s how:

1. Push the “TEST” button on each RCD breaker, and observe it click OFF.

2. Push the breaker switch to the OFF position (to ensure that it has completely disengaged),

then push the breaker switch to the ON position.

If any of the RCD breakers fails to operate in this manner, your spa may have an electrical

malfunction, and you may be at risk of electrical shock. Turn off all circuits and do not use the

spa until the problem has been corrected by an authorized service agent.

WARNING: Removing or bypassing any RCD breaker will result in an unsafe spa and will void

the spa’s warranty.

IMPORTANT: Should you ever ﬁnd the need to move or relocate your Arctic Spa, it is

essential that you understand and apply these installation requirements. Your Arctic Spa has been

carefully engineered to provide maximum safety against electric shock. Remember,

connecting the spa to an improperly wired circuit will negate many of its safety features.