Specifications

Venturi Controls
13
13
Fusion Jetting System
TM
the water temperature to stabilize (approximately 16 hours). Make sure you secure the cover
in place using the cover locks. Periodically check the spa water temperature. When the wa-
ter temperature climbs above 29°C, proceed to the next step.
9) Test and Adjust Sanitizer level (Chlorine ideal 1 - 3 ppm or Bromine ideal 3 - 5 ppm).
10) You can set the temperature (between 38°C and 40°C, 100°F to 104°F) by pressing the
TEMP ( ) and TEMP ( ) buttons on the control panel. The spa will normally come
up to temperature within 16 to 24 hours. Replace the spa cover while the temperature is
reaching the set point.
IMPORTANT: For safety, you can lock your desired temperature setting. Refer to the Topside
Control Panel section for details.
With your Fusion
TM
Jetting System, you can control the massaging action of your spa. Using
the Fusion
TM
diverter, the jets are activated in groups, known as jet systems. The jetting systems
are selected by turning the diverter from one side to the other, or select both by leaving the di-
verter in the middle. The number of diverters you will have will depend on the model and series
of Arctic Spa you have. Feel free to consult your local dealer with any questions regarding the
function of this system, or just jump in and experiment for yourself.
The Venturi Controls allow you to control the intensity of the massage at each jet by
adjusting the mixture of air and water. Simply turn the venturi control lever counter-
clockwise for a stronger flow and clockwise for a softer flow. Most jets are adjustable by turn-
ing the face of the jet counter-clockwise for a stronger flow and clockwise for a softer flow and
eventually off.