Specifications

15
15
“Clean filter” reminder:
If enabled, the display will start flashing every 2 weeks showing the “CLE” message. This message is
displayed to remind the user to clean the filter cartridge. Press any key to reset the message.
Setting the Water Temperature:
Use the Up or Down arrow key to regulate the water temperature. The temperature setting will me
displayed for 5 seconds to confirm your new selection
The “Set Point” symbol indicates the desired temperature, NOT the current water
temperature!
The water temperature can be adjusted by 1 degree increments from 59 to 104ºF
(15 to 40ºC)
Starting Pump 1:
Press the
Pump 1 key to turn Pump 1 on at low speed. Press a second time to turn
Pump 1 to high speed. A third time turns Pump 1 off. A built-in timer automatically turns
Pump 1 off after 20 minutes, unless it has been manually shut off.
The “Pump 1” indicator lights up when Pump 1 is running at high speed. It flashes when Pump 1 is
on at low speed.
Note: Pushing and holding the Pump 1 button will lock the panel. See the section “Panel Lock” for
details.
Starting Pump 2 (Optional):
Press the Pump 2 key to turn Pump 2 on. A second time turns Pump 2 off.
A built-in timer automatically turns Pump 2 off after 20 minutes, unless it has been
manually shut off..
The “Pump 2” indicator lights up when Pump 2 is running at high speed.
Starting Pump 3 (On/Off Button) (Optional):
Press the Pump 3 key to turn Pump 3 on. Press a second time to turn Pump
3 off. A built-in timer will automatically shut Pump 3 off after 20 minutes,
unless it has been manually shut off.
Note: If Pump 3 is not present, then this switch is used only for the Standby mode. (Use this when
you’re checking inside the equipment bay, or while you’re changing a filter.)
A long press (5 seconds) on Pump 3 key puts the system on standby. In Standby mode, the display
shows “OFF” for at least 10 seconds and all outputs are turned off for 30 minutes. If the heater is