Use and Care Manual

15
Battery Size: AAA - NOTE: Do not mix old and new batteries or different types of AAA batteries..
TURBO: When the remote is
ON,
pre
s
s
the
TURBO button to activate high fan mode.
NOTE For °F to°C change
: After inserting
the batteries in the off state, within 3 minutes,
press and hold TURBO button for 5+ seconds
to switch display from °F to °C.
1. POWER: Turn the air conditioner on and off.
2. MODE : Press the button to select the mode
of operation, AUTO, COOL, DRY and FAN
3.
^
" " and " ":
^
Use these buttons to increase
or decrease the Set Temperature or Timer.
Temperature range is 61°F to 88°F (16°C-31°
C)
4.
9.
8.
5. DISPLAY :
By pressing the DISPLAY button, this
will
switch off/on all lights or LED display.
7.
6.
TIMER: Use the buttons on the control panel and
remote to set the TIMER
Timer Off: When the unit is on, timer can be set
by pressing the TIMER button. Set the run time
by pressing the up " " or down " " button until
the desired run time is displayed, then press
TIMER button again.
Timer On: When the unit is off, press the TIMER
button, set the time by pressing the " " or " "
button. Press TIMER button again to confirm the
setting. Both the TIMER on and off indicators will
illuminate once set.
NOTE: It can be set to automatically turn off or on
in 30 minutes to 24 hour intervals. Each press of
the " " or " " buttons will increase or decrease
the timer. The TIMER can be set in 30 minute
increments up to 10 hours, and 1 hour increments
for 10 or hours and above. The SET light will turn
on while setting. To cancel the set function, press
the TIMER button again.
"I FEEL": Press the "I FEEL" button to activate
the follow me function, which enables the remote
to take the temperature at its current location, and
send this signal to the air conditioner to optimize
the temperature around you and ensure comfort.
FAN: Press the "FAN" speed button to select the
from fan options. You can choose Hi, Med, Lo or
Auto in Cool Mode, and Hi, Med, Lo in Fan Mode.
ECO: When the unit is in ECO mode, the light will
illuminate. In ECO mode, the unit will turn off
once the room is cooled to the set temperature.
The unit will turn back on when the room
temperature rises above the set temperature.
Before the compressor starts, the fan motor will
keep cycling, to provide for a comfortable
environment, while saving energy.
I FEEL
ECO
FAN
1
2
33
4
5
6
7
8
9
>
>
*NOTE: Models 1DACH18K & 1DACH24K also have heating
modes. This function can be reached using the "MODE" button.
*
USING YOUR REMOTE CONTROL