User's Manual
Table Of Contents
- Hub Installation Checklist – 6x60-degree
- Link Budget Parameters for 6x60 Hub
- Wireless Cable Modem Configuration – CXC150W
- W-CMTS BSR1000W Setup Guide
- Factory Settings BSR1000W
- Connecting to the BSR1000 CMTS
- Setting the System Passwords
- Configure the Ethernet IP Address
- Configure Cable IP Address
- Configure the CMTS
- Configure Downstream Port
- Configure Upstream Ports:
- Configure Basic Routing
- Save the Configuration
- Creating a static route from the server to the BSR1000
- Windows 2000 DHCP Server
- Time-of-Day Server Setup Guide
- BSR1000W SNMPc View and Community
- SolarWinds’ TFTP-Server
- Cable System Basics
- Reader Feedback
9.11 Creating a static route from the server to the BSR1000
A static route must be set on all servers on the network that will communicate to the
cable interface (e.g. modems) of the BSR1000.
29. Windows 2000 Server: At DOS command prompt
• Route add <destination> mask <subnet> <gateway> -p
• Example: route add 192.168.2.0 mask 255.255.255.0 10.10.10.203 –p
• 10.10.10.203 is the Ethernet IP address of the BSR1000
June 2003 Page 9-5