User's Manual
Table Of Contents
- Hub Installation Checklist – 6x60-degree
- Link Budget Parameters for 6x60 Hub
- Wireless Cable Modem Configuration – CXC150W
- W-CMTS BSR1000W Setup Guide
- Factory Settings BSR1000W
- Connecting to the BSR1000 CMTS
- Setting the System Passwords
- Configure the Ethernet IP Address
- Configure Cable IP Address
- Configure the CMTS
- Configure Downstream Port
- Configure Upstream Ports:
- Configure Basic Routing
- Save the Configuration
- Creating a static route from the server to the BSR1000
- Windows 2000 DHCP Server
- Time-of-Day Server Setup Guide
- BSR1000W SNMPc View and Community
- SolarWinds’ TFTP-Server
- Cable System Basics
- Reader Feedback
10 Windows 2000 DHCP Server
This Section is written for both the Motorola BSR1000W and for the Vyyo V3000
wireless CMTSs.
Most of the text is for a Motorola BSR1000 system. With the exception of the IP
Addressing scheme, all other DHCP parameters values are valid for a Vyyo WMTS. Pay
particular attention to any bold captions under screenshots for changes for Vyyo systems.
Requirements:
- Windows 2000 Server with DHCP installed
10.1 Setup Procedures
1. In the “Administrative Tools”, open DHCP.
2. Highlight the NMS machine and add a new scope by clicking on “Action” > “New
Scope”.
3. Follow the on screen instructions entering necessary instructions
a. IP Address Range – Specify the valid address range for the server
June 2003 Page 10-1