User's Manual

Installation Guide
20 of 27
PARAMETER DESCRIPTION
Alarm Mask (Continued)
0095 (Hex), which corresponds to 10010101
(Binary). The bits that correspond to the alarms we
want turned on have been set to 1 and the rest have
been set to 0.
The defautl setting is all F’s.
Alarm Destination
Enter up to (5) IP addresses where SNMP traps are
to be routed to by the Hub.
The default setting is all 0”s.
Real time monitor
Click on the “Apply” button to refresh the Real
Time Monitor display which captures all the values
in the radio manager registerts.
PureBurst
Choose “On” to enable PureBurst and “Off” to
disable PureBurst. When no traffic is present on the
upstream cable interface, PureBurst mutes the
interface preventing the introduction of ingress noise
into the cable network.
The default setting is “On”.