User's Manual

may
Search, detection, and alarm range depend on the terrain environment.
kitthe the
If the beep sound is not loud enough, the batteries may be low. Change with new batteries for louder alarm sound.
use the device trips,
batteries
your
batteries sources. It may cause danger or even explosion.
Sleeping
Low battery
Mute
For 1 master and 1 slave: Press the Mute button to mute searching melody from the Master unit. Listen to
beep sound from the Slave unit to assist short range searching.
For 1 master and 2 slaves: Keep pressing the Serach button to mute searching melody from the Master unit.
List beep sound from the Slave unit to assist short range searching.
1. To avoid the pairing failure, please make sure the Slave 1, 2 and Master unit are under power off status.
2. Press the "left" key on Master unit and turn on the Power at the same time. At the moment, two of the LEDs
light.
(As Graph 1)
3. Keep pressing "left" key and press the "right" key. Then release "left" key and LEDs start flashing, and then
release "right" key.
4. At this moment the Master unit is under code-setting status and awaiting to be paired.
(As Graph 2)
5. Turn on the power of Slave unit and position it 5~10cm from Master unit to proceed the pairing.(As Graph 3)
6. While Master unit and Slave unit are paired, both units enter Search mode.
The pairing process of additional Slave unit
Graph 1
Graph 2
m
l
b.) When switching the Master unit power on, the Signal indication LED flashed as searching the
Slave unit. If the Master and Slave units are out of working range, the Signal indication LED
remains light while the Master unit could not find Slave unit.
Switch the power button of the Master unit to OFF, when search function is not needed. Once you need this
kit to resume the standy mode, just turn the power button of the Master to ON.
Important: a.) Please keep the Slave at ON status if you would turn the Master into Sleep mode.
c.) Please trun off the Master and Slave unit if NOT in sue to save battery life.
o
5~10cm
Graph 3
Signal indication LEDs flash
every second
Melody is rapider
Melody is slower and diminuendo
Signal indication LEDs flash
every second
Melody is slower and short
beep every second
!
Alarm
Diasble Alarm funstion: During at standby
mode, the master and Sllave wuthin 2
meters, power off the Master unit.
Enable Alarm function: Switch the Master
power on.
Switch the Power button to ON
More LEDs light up
LEDs light decreasingly
Turn off the search melody of Master(long press the Mute button)
Search
Signal indication LEDs flash
Signal indication LEDs flash
every second
Signal indication LEDs flash
every second
High beeps while re-linking
High beep every second
Low battery
Disconnect
Under standy mode, press the
”Search” button
This product operation temperature is between 32ʲ ~140ʲÛ&aÛ&. Storage temperature is between -4ʲ ~185ʲ
Û&aÛ&
91E-02B5-U50G00
** The connection range depends on the terrain
environment because of readio efficiency.