User's Manual

Base Unit
Search button
Press to search for the Tag unit.
Model Name
708A3
Base Unit
Tag Unit
1 pc
Batteries
CR2032x1, AAAx2
User manual
Strap
Hook
1
1
Base Unit
Tag Unit
1 pc

Tag Unit
Model Name
Function
Search Range
Alarm Triggered
Base Unit / Tag Unit
Base (M08AM)x1
Battery Type CR2032
Battery Life Time on Standby
45 days
Beep Audible Level (at 10 cm / 3.9 inches) 95 db
Dimension (L/W/H)
Bike Guard 708A3
Alert & Search
0~500m/1600ft
1
2
Speaker
Sound output
BIKE GUARD 708A3 USER MANUAL
Bicycles are stolen everywhere and every day no matter they are with or without locks. To protect your bicycle
from being stolen, our Digital RF wireless bicycle alarm system can be your best solution. Once the bike theft
happens, the Bike-Alarm will sound loud beeps to scare the thief away and the Beeper will also immediately
activate an emergency alarm to warn you to check the bicycle and take the necessary actions urgently.
Therefore, with Bike Guard 708A3 armed on the bicycle, whenever you want to take a short break in the cycling
journey, there is no need for you to worry about parking your bike nearby.
1
2
3
4
5
6
Ring attachment
Speaker
Connecting status
Power switch
Battery cover
Power ON/OFF
Show the signal synchronous status between Base and Tag unit
Sound output
Ta g ( S 0 7 C ) x 1
Vibration Sensor
Front
Back
1
2
61.5x36x11.6mm
2.42x1.42x0.46inch
Front
Back
1
2
3
4
5
6
INTRODUCTION
1
Product Description
Specification
Package Contents
How to apply/wear the Base and Tag units.
GETTING STARTED
2
This section shows how to quickly setup and trigger an alert condition.
1.
Place battery into the Base unit and the Tag unit.
Base Unit
ALERT
3
A sensor is built-in to detect the vibration, while someone is trying to move your bike, the Bike
Guard will alert you in 2 seconds. The Base&Tag unit will alarm for 10 seconds and repeat alarm
until vibration is stop.
Disarm Alarm:
Under standby mode, turn OFF the Master unit within 1 meters from your bicycle, the Tag unit will
sound "Di-du" to approval disarm. When you hear "Di-du", you have disarmed Bike Guard.
Screw Hole
110db
AAAx2
70 days
127x40x12mm
4.99x1.57x0.47inch
2. Make sure that the Base and Tag units are in close proximity.
3. Turn ON the Power switch on the Base units. The base
units will establish a link and begin to blink synchronously .
4. Shock the Tag unit, and the base unit and Tag unit will beep.
5. Congratulations, now you are ready to put the Tag unit underneath the
bottle cage on a bike (in case the alarm is triggeved while installation).
Tag Unit
Beep Beep...
Beep Beep...
Open the battery cover by placing your thumb on the cover
(as shown) and pulling it backwards until it clicks open;
then lift off the cover.
Insert the battery into the battery compartment with the “+”
sign on the battery facing up. Then replace the battery
cover by sliding it up into compartment opening.
a) Open from the fillister on the button of housing or curve
side by your nail, like open shell.
b) Insert batteries (included) following the polarity
markings in the battery compartment.
c) Close the battery compartment cover.
Reminder Power Switch
BIKE GUARD 708A3 USER MANUAL
Page 1
Page 2