Data Sheet

CSI-HDMI Adapter Board for Raspberry Pi Camera Board
www.Arducam.com
2
4. Headphone Jack Wiring Diagram
5. Assembly Instructions
Assembly is simple but require precision to place and tighten the small M2 screws (4mm). To
reproduce the setup shown on the first picture:
 1 - Assemble the 80mm flat cable between the camera and board, watch carefully the
picture for the side of the cable; the connections face away on the extension board and
toward the camera.
 2 - Lock the connectors in place, here it helps to have long nails. This is mandatory for a
good connection.
 3 - Place the boards back to back, the flat ribbon should form the shape of an "S".
 4 - First with your fingers and maybe tweezers set a screw and spacer loosely. Set another
on the opposite side and tighten a bit. Then place the two remaining screws, tighten
everything with a small screw driver and a 4mm wrench or a pair of pliers.