ArduCAM USB3 Camera Shield User Guide Rev 1.
ArduCAM USB3 Camera Shield User Guide Table of Contents 1 2 2.1 2.2 3 4 4.1 4.2 4.3 4.4 4.5 4.6 4.7 Introduction ............................................................................................................................. 2 Hardware Installation............................................................................................................. 2 Primary Camera Interface .............................................................................................
ArduCAM USB3 Camera Shield User Guide 1 Introduction This user guide describes the detail operation of ArduCAM USB3 camera shield. The latest device driver, SDK library and examples can be downloaded from the https://github.com/ArduCAM/ArduCAM_USB_Camera_Shield. 2 Hardware Installation There are two camera interface provided on the USB3 camera shield, but only one camera interface can be used at a time. 2.
ArduCAM USB3 Camera Shield User Guide Table 1 8-bit Camera Interface Pin Definition (Connector Part Number: Hirose FH28D-30S-0.5SH(05)) Pin No.
ArduCAM USB3 Camera Shield User Guide Table 2 16-bit Camera Interface Pin Definition (Connector Part Number: Harwin M50-4302045) Pin No. PIN NAME TYPE Pin No. PIN NAME TYPE 1 VCC3.3 POWER 2 VCC3.
ArduCAM USB3 Camera Shield User Guide Go to Start->Settings->Control-Panel->Device Manager, right click the unknown device and select "Update Driver Software". Select the "Browse my compute for driver software" Select "Let me pick from a list of device drivers on my computer". 5 www.ArduCAM.
ArduCAM USB3 Camera Shield User Guide Select "Show All Devices". Press the "Have Disk" button. Enter the path to the ArduCAM USB3 driver, where you save the downloaded file from github. 6 www.ArduCAM.
ArduCAM USB3 Camera Shield User Guide Confirm the installation of the driver by pressing "Yes". Confirm the installation again by pressing "Install". You will successfully install the driver like this. 4 Demo Code The demo code is provided in source code form to help user to understand the operation the ArduCAM USB camera and SDK library. It is created with Microsoft Visual Studio 2013 and 7 www.ArduCAM.
ArduCAM USB3 Camera Shield User Guide based on MFC frame work. The Windows demo code is located in ../Winodws/USBTest folder and the release executable software is located in ../ Winodws/USBTest/USBTest.exe. 4.1 Scan Cameras Click the scan button, the drop down list will show all supported cameras with serial number, user can select one of them to open. 4.
ArduCAM USB3 Camera Shield User Guide the video position. 4.9.2 Force Display Force display is useful to debug the problem by force displaying the wrong video data which is mismatch with the camera preset values. 4.9.3 IRcut It can be used to manual control extra motorized IRCUT filter for both daylight and night vision. 4.9.4 Frame Rate Information The frame rate information show the capture frame rate and GUI display frame rate.
