User Guide

ArduCAM USB3 Camera Shield User Guide

1 Introduction

This user guide describes the detail operation of ArduCAM USB3 camera shield. The latest

device driver, SDK library and examples can be downloaded from the

https://github.com/ArduCAM/ArduCAM_USB_Camera_Shield

2 Hardware Installation

There are two camera interface provided on the USB3 camera shield, but only one camera

interface can be used at a time.

2.1 8-bit Camera Interface

The primary camera interface is used for camera breakout board with 30pin ribbon cable. The

pin definition is shown in Table 1. Although the camera breakout board might has more than 8bit

data bus, only the upper 8bit connected to the USB camera shield through this FPC connector.